LED SOLAR PARK LIGHT VIDEX IP54 1200Lm with motion Sensor VL-GLSO-1254-S

LED Solar Park Light with motion sensor VIDEX VL-GLSO-1254-S is a modern and efficient lighting fixture designed for independent illumination of sidewalks, park paths, parking lots, courtyards, and other open spaces. The light operates on a built-in battery and does not require connection to the mains. Thanks to its modern design and advanced technology, it blends harmoniously into any outdoor environment, providing effective lighting and a comfortable space for users. PACKAGE CONTENTS: - Light fixture; - Mounting connector; - Hex screws (3pcs); - Hex nuts (3pcs); - PVC caps (3pcs); - Remote control; - AAA batteries (2pcs); - Individual packaging. FEATURES: - High-efficiency solar panel; - High-quality optical lenses and illumination; - Beam angles – 60° and 360°; - Luminous flux – 1400Lm; - Light color temperature – 5000K + 3000K; - Long battery runtime – up to 14 hours; - Dust and water protection level – IP54; - Impact protection class – IK06; - Remote control; - Built-in motion sensor; - Intelligent operation mode. INSTALLATION INSTRUCTIONS Read the user manual before installation and use. The light fixture and solar panel are inseparable parts. Individual parts cannot be used separately. The fixture should be installed on a stable base parallel to the ground. To complete installation, follow these steps: a) Remove the mounting connector and loosely install screws and nuts; b) Insert the mounting connector and rotate it to the locked position following the arrow; c) Ensure the mounting base fits poles with a diameter of 65–75mm. Place the connector on the pole and then use a tool to securely tighten the screws with the pole (pole and tool not included); d) Cover screw holes with PVC caps. Press and hold the switch on the control panel for 2 seconds to turn on the light and complete the installation. USER INSTRUCTIONS The solar panel converts sunlight into electricity and charges the battery. The light control circuit automatically charges the battery during the day (>10 lux) and discharges it at night (<5–10 lux). Ambient temperature for charging should be above 0°C, and for operation (discharging) above -10°C. Note: - Before regular use, make sure the light is fully charged for 8 hours under direct sunlight. - Avoid shading the solar panel with trees, buildings, or other objects, as this may reduce performance. REMOTE CONTROL: 1. Forced On. Press once to turn on the light. The «Auto» discharge program will be applied. 2. Forced Off. Press once to turn off the light. 3. Halo. Press to enable additional decorative lighting (3000K). The halo will turn on together with the main light. Press again to turn it off. 4. Induction Mode¹. Press to activate motion sensor mode. No motion detected – 8% brightness; motion detected – 100% brightness. A steady green indicator means the mode is active. 5. 4h + Induction¹. The first 4 hours use the «Auto» program, then the motion sensor mode is applied (no motion – 8%; motion – 60%). A blinking green indicator means the mode is active. 6. 3-hour Timer¹. Runs for 3 hours at 75% brightness, then automatically turns off. 7. 6-hour Timer¹. Runs for 6 hours with the «Auto» discharge program, then automatically turns off. 8. «Auto» Mode¹. Operates first 0.5 hours at 60% brightness, next 1.5 hours at 50%, next 4 hours at 30%, remaining 8 hours at 10% or until battery discharge. ¹The selected mode will be remembered and applied every evening. Additional operation recommendations are provided in the user manual. During long-term storage, it is recommended to keep the battery charged to about half of its capacity to extend its lifespan. Do not store with a fully discharged battery. To maintain original performance, clean the solar panel every 3–4 months. Warranty is 2 years.